템플릿 Construction North houston pole line daily audit North houston pole line daily audit 이 양식에 포함된 내용 이 양식에는 17개의 섹션이 있습니다: Task Hazard AnalysisWas a THA completed for all tasks being performed? Add media Mechanical EquipmentHave pre-use inspections been completed for all equipment in use at the site?Is the equipment in satisfactory condition? HousekeepingHas the contractor addressed all housekeeping issues on the job site?Are flammable liquids stored in approved containers or tanks? CommunicationsIs a complete Emergency Action Plan documented and on site?Has the plan been reviewed with all employees?Are there at least 2 CPR/First Aid trained per crew?Are adequate first aid supplies available?Are MSDS's readily available?Is a copy of the company safety manual on site? Hand ToolsAre all electrical tools in good working condition?Are all ladders in good working order? Personal Protective EquipmentAre all employees wearing at minimum a hard hat, ANSI approved safety glasses w/sideshields, safety toed boots, and a highly visible top?Are employees wearing work gloves appropriate for the hazard?Are all employees wearing 100% fall protection when required?Is PPE in good condition?Are test dates on rubber goods current?Are test dates on hot sticks current?Is all PPE being stored properly to prevent damage? Work performed under an operating orderDo the foreman and crew know who holds the clearance, non-reclose order or hold order for the facilities being worked?Do the foreman and crew know and understand clearance points? Working on or Near Energized EquipmentAre all employees maintaining appropriate approach distances?Are all energized facilities covered or guarded to prevent contact?Has the foreman been advised of equipment under an NRO?Has the contractor logged in with dispatch? Work Zone ProtectionAre the workers properly protected from vehicle traffic?Have all permits been obtained for any public road crossings?Been guarded?Have all hotline crossings been properly guarded?Have utilities been located and marked if any digging or excavating activities are being performed? GroundingHave all lines and equipment been de-energized, tested, and grounded when required?Have all sources of energy been considered including induced voltage? OSHA TrainingHas supervisors completed OSHA 30 hour training?Have all employees completed OSHA 10 hour training? RiggingIs all rigging equipment in satisfactory condition?Is the rigging being protected from sharp edges? Foreman Safety Supervisor 이 템플릿 사용